Wyoming WYDOT CDL General Knowledge Practice Test 10
- Questions50
- Correct to pass40
- Passing score80%
- Minimum age18 years
-
1. Which factors determine a safe speed for a long, steep downgrade?
Show answer
Answer C: The steepness and length of the grade, the weight of the vehicle and cargo, and the road and weather conditions
Gravity, weight and traction all decide how fast a heavy vehicle can safely descend, which is why signs often post lower speeds for trucks on grades.
-
2. Why should the radio, the fan and other noisy equipment be switched off during a required stop at a railroad crossing?
Show answer
Answer C: So that an approaching train can be heard
The rules require the driver to look and listen along the track, and on a double track crossing a passing train can hide a second one, so hearing matters as much as seeing.
-
3. How should the headlamps be checked during the pre-trip inspection?
Show answer
Answer A: By switching on both low beam and high beam and confirming each one works outside
Both beams are separate circuits, so each is switched on in turn and confirmed from outside the vehicle where the lamps can actually be seen.
-
4. Under federal safety rules, what must the driver of a commercial vehicle do before starting a trip?
Show answer
Answer A: Be satisfied that the vehicle is in safe operating condition
The driver is responsible for inspecting the vehicle and must be satisfied it is in safe operating condition before the trip begins.
-
5. After the first inspection of a trip, how often must cargo securement be checked again?
Show answer
Answer D: Every 3 hours or 150 miles or at each change of duty status, whichever happens first
The load must be re-checked at whichever of those points arrives first, so a loosening tiedown is found long before it fails.
-
6. A tire blows out at highway speed. What should the driver do first?
Show answer
Answer C: Hold the steering wheel firmly, stay off the brake and let the vehicle slow down
Braking while a tire is gone can pull the vehicle out of line, so the driver keeps it straight and lets speed fall before easing off the road.
-
7. How is free play in the steering wheel measured during the inspection?
Show answer
Answer B: By turning the wheel until the front wheels just start to move and noting the movement
Play is the movement at the rim that produces no movement at the road wheels, so it is measured by turning until the wheels first respond.
-
8. Where on a tire is tread depth measured?
Show answer
Answer C: In a major tread groove, away from any tie bar or wear indicator
Depth is taken in a major groove and away from the raised tie bars and wear indicators, which would give a shallower and misleading reading.
-
9. Two tires in a dual set have noticeably different diameters. Why is that a problem?
Show answer
Answer C: The larger tire carries more than its share of the load and can be overloaded
The taller tire touches the road first and takes most of the weight, so it runs overloaded and hot while the smaller one does little work.
-
10. While checking the in-cab gauges after start-up, what should the coolant temperature gauge do?
Show answer
Answer C: Rise gradually to the normal operating range
A healthy cooling system warms the engine slowly; a gauge that shoots up or stays cold points to a problem with the thermostat, coolant or sensor.
-
11. What should you look for on the electrical wiring in the engine compartment?
Show answer
Answer A: Worn, frayed or cracked insulation and loose or corroded connections
Damaged insulation can short a circuit against the frame or engine, which can kill a lamp you depend on or start a fire.
-
12. What does the suspension system weight rating tell the driver?
Show answer
Answer A: The maximum weight that the manufacturer says the suspension can carry
Like tires and axles, suspensions have a manufacturer capacity, and loading beyond it can damage springs and air bags.
-
13. Why should a retarder be switched off when the road is wet, icy or snowy?
Show answer
Answer C: It can make the drive wheels skid when traction is poor
A retarder slows the drive wheels only, and on a slippery surface that braking force can break their traction and start a skid.
-
14. Apart from the risk of stalling, why is rolling backwards when starting on an upgrade so serious in a heavy vehicle?
Show answer
Answer D: You can strike the vehicle behind you, which is often much closer than you think
You cannot see how close the vehicle behind has stopped, and even a short roll back is enough to hit it.
-
15. Why should a long vehicle never swing out to the left before starting a right turn?
Show answer
Answer D: Another driver may read it as a left turn or pass on your right
Swinging left opens a gap on your right that a car will move into, and it also sends a false message about which way you are going.
-
16. What is the main purpose of a retarder fitted to a heavy vehicle?
Show answer
Answer B: To help slow the vehicle and reduce the need to use the service brakes
Exhaust, engine, hydraulic and electric retarders all slow the vehicle so the brakes stay cool and wear less, especially on grades.
-
17. You are unsure whether your vehicle will fit through a narrow gate. What should you do?
Show answer
Answer A: Stop, get out and look, and take another route if the space is not clearly enough
Clearance is never guessed at from the seat; you look at it on foot and go round rather than trying a gap that may be too tight.
-
18. Where do you find the maximum weight a tire can safely carry?
Show answer
Answer D: Stamped on the sidewall of the tire itself
Each tire is marked with the greatest weight it can carry at a stated inflation pressure, and the load on an axle must stay within the total for its tires.
-
19. Federal rules say a commercial vehicle may not be driven unless what is true of its cargo?
Show answer
Answer B: It is properly distributed and adequately secured
The basic federal requirement is that the load be distributed properly and secured well enough that it cannot move, whatever the paperwork says.
-
20. What blood alcohol concentration disqualifies the holder of a commercial driver license who is operating a commercial vehicle?
Show answer
Answer D: 0.04 or higher
Commercial drivers are held to 0.04, half the limit that applies to a driver of a passenger car in the same state.
-
21. Part of your load stands high enough to hide a rear lamp or a reflector. What must be done?
Show answer
Answer B: The load must be moved or extra lamps fitted so the required lights can be seen
Required lamps and reflectors must remain visible; if the cargo blocks them, the load is rearranged or additional lamps are fitted so the vehicle can still be seen.
-
22. Why does the commercial driver manual tell you to look far down the road instead of only at the vehicle ahead?
Show answer
Answer D: So you can adjust smoothly instead of braking hard at the last moment
A heavy vehicle cannot react quickly, so early information lets you slow gradually rather than make a sudden stop or swerve.
-
23. What is generally the safest speed in dense but freely moving highway traffic?
Show answer
Answer D: The speed of the traffic around you, up to the posted limit
Crashes rise with the difference between your speed and the traffic around you, so moving with the flow within the legal limit is safest.
-
24. What should a driver assume about the height posted at a bridge or an overpass?
Show answer
Answer B: That it may be wrong, because repaving or packed snow can leave less clearance than the sign shows
Resurfacing and packed snow raise the road under the structure, so the real clearance can be lower than the posted figure.
-
25. Which set of maneuvers makes up the basic control skills part of the commercial driving test?
Show answer
Answer D: Straight line backing, offset backing, parallel parking and alley docking
The basic control skills test is carried out off the road and consists of low speed exercises such as straight line backing, offset backing, parallel parking and the alley dock.
-
26. Which vehicle is most likely to be pushed around by a strong crosswind?
Show answer
Answer B: An empty van trailer
A large flat side with very little weight behind it gives the wind the most surface and the least resistance, which is the empty van trailer.
-
27. What must be true of the trailer landing gear before you move off?
Show answer
Answer B: Fully raised, with the crank handle secured and no missing or damaged parts
Landing gear left part way down can strike a railway crossing or a ramp, and a loose crank handle can swing out into a passing vehicle.
-
28. You are moving an oversized load under a permit that requires a pilot vehicle. What is the pilot vehicle there to do?
Show answer
Answer B: Warn other traffic and check the route ahead for clearances and hazards
Escort or pilot vehicles warn approaching traffic and scout the route for low bridges, narrow spots and other hazards that a wide or long load cannot pass.
-
29. Loading heavy freight on top of lighter freight has what effect on the vehicle?
Show answer
Answer B: It raises the center of gravity and makes a rollover more likely
A high center of gravity lets the vehicle tip more easily in curves or during a sudden swerve.
-
30. Compared with a fully loaded one, an empty truck under hard braking will often do what?
Show answer
Answer A: Need a longer distance to stop because traction is poor
Stiff suspension and little weight over the tires reduce grip, so the wheels lock early and the vehicle can take longer to stop.
-
31. Besides staying secure, cargo carried inside a vehicle must not do what?
Show answer
Answer C: Block the driver view or access to emergency equipment and exits
Cargo may not obstruct the view to the front or sides or prevent the driver from reaching emergency equipment and exits.
-
32. A company mechanic serviced your truck this morning and signed the work order. Do you still have to inspect the vehicle?
Show answer
Answer B: Yes, the driver is still responsible for being satisfied the vehicle is safe
Shop work does not transfer the duty; the driver who takes the vehicle out remains responsible for being satisfied it is in safe operating condition.
-
33. How does a driver measure following distance in seconds?
Show answer
Answer A: Wait for the vehicle ahead to pass a fixed roadside object, then count the seconds until the front of your vehicle reaches the same object
Counting from the moment the vehicle ahead passes a landmark until you reach it turns a gap you cannot judge in feet into a number of seconds.
-
34. A commercial driver is convicted of two serious traffic violations within three years. What is the result?
Show answer
Answer D: Disqualification for 60 days
Two serious traffic violations in a three year period bring a 60 day disqualification, and a third in the same period raises it to 120 days.
-
35. What must the driver check about the seat belt during the inspection?
Show answer
Answer A: That it is securely mounted, adjusts properly and is not ripped or frayed
A belt only restrains the driver if its anchorage is sound and the webbing is intact, so mounting and condition are both checked.
-
36. What happens to braking distance when speed is doubled?
Show answer
Answer C: It becomes about four times longer
Braking distance grows with the square of speed, so doubling the speed multiplies both the braking distance and the force of an impact by about four.
-
37. Why is cargo often covered with a tarp?
Show answer
Answer C: To protect people from spilled cargo and to protect the cargo from weather
A cover keeps material from blowing or spilling onto the road and shields the load from rain and sun; it does not replace securement.
-
38. What do you check about the fire extinguisher during the pre-trip?
Show answer
Answer C: That it is securely mounted, charged and that you know how to operate it
An extinguisher must be held in its bracket, show a charged gauge and be understood by the driver, because a fire leaves no time to learn.
-
39. At the scale your tractor drive axles are overweight while the trailer axles have room. Sliding the trailer tandems forward will do what?
Show answer
Answer C: Move weight off the drive axles and onto the trailer axles
Sliding the trailer tandems forward brings the rear support closer to the load, so the trailer axles pick up more weight and the drive axles carry less; sliding them rearward does the opposite.
-
40. What is the minimum age to hold a Wyoming commercial driver license?
Show answer
Answer B: 18 years
WYDOT states that a person under 18 years of age cannot be issued a Wyoming commercial driver license.
-
41. Cargo falls from your trailer and causes a crash behind you. Who is likely to answer for it?
Show answer
Answer C: The driver and the carrier, since securing the load on the road is their duty
Whoever loaded the vehicle, the driver and the carrier are responsible for the load being secure while it is on the road.
-
42. Besides the hours when the law requires them, when should headlights be switched on?
Show answer
Answer A: Any time visibility is poor, such as in rain, fog or at dusk
Headlights are used to be seen as much as to see, so they belong on whenever light or weather makes the vehicle harder to spot.
-
43. How are the extra gears of a multi-speed rear axle or auxiliary transmission usually controlled?
Show answer
Answer D: With a selector knob or switch on the gearshift lever of the main transmission
A range selector on the shift lever lets the driver choose the extra gear range while shifting the main transmission.
-
44. Why does extra weight make a long downgrade more dangerous even when the brakes are in good order?
Show answer
Answer B: Gravity adds to the momentum and the brakes heat up faster
The heavier the vehicle, the more energy the brakes must turn into heat, and heat is exactly what makes brakes fade on a long descent.
-
45. Within what distance should high beams be lowered at night?
Show answer
Answer D: Within about 500 feet of an oncoming vehicle and within about 500 feet of a vehicle you are following
High beams blind other drivers at close range, so they are lowered at roughly the same distance whether the other vehicle is coming toward you or is ahead of you.
-
46. Why does a load of live animals need special attention?
Show answer
Answer D: The animals move and lean, so the center of gravity shifts and the vehicle can be pushed off balance in a turn
A live load will not stay where it is put, and that movement changes the balance of the vehicle exactly when a curve is loading it most.
-
47. How are Wyoming CDL written tests structured and scored?
Show answer
Answer A: All written tests are multiple choice and require 80 percent to pass, and only the failed test has to be retaken
WYDOT states that all CDL written tests are multiple choice, that the passing score is 80 percent, and that an applicant who fails only has to retake the test that was failed.
-
48. A load overhangs the rear of the trailer. What must the driver check before leaving?
Show answer
Answer D: That the overhang is marked as required, with flags or lamps as conditions demand
A projecting load has to be made visible to other drivers, with flags in daylight and lamps when lights are required, so nobody runs into what they cannot see.
-
49. You hear air escaping from a trailer tire during the pre-trip. What should you do?
Show answer
Answer C: Have it repaired or replaced before the vehicle is driven
An audible leak means the tire is failing now, and federal rules do not allow a vehicle to be operated on a flat or leaking tire.
-
50. You press on a drive belt and it deflects far more than the others. What does that suggest?
Show answer
Answer C: The belt is too loose and the part it drives may not work properly
A belt with excessive play slips on its pulleys, so the accessory it drives turns too slowly or not at all under load.